Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255735 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)  Key-off Operation Function Operates even if Operating Conditions are not Satisfied  


DESCRIPTION

·

When the front doors are closed, each power window regulator motor can control its power window operation for approximately 45 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU.


·

However, when approximately 45 seconds have elapsed, or the driver side door or front passenger side door is opened within approximately 45 seconds of the ignition switch being turned off, the power window regulator motor stops operating.


·

During the auto function operation, when 45 seconds have passed and key-off operation is prohibited, the window operation stops immediately.


·

The front passenger side power window and the rear power windows cannot be operated when the window lock switch is on.


PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
a.

Check for LIN communication system DTCs related to the power window control system (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).

OK:

LIN communication system DTCs are not output.




OK

2.CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF

NG

2.CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF
a.

Check the power window operation function after the ignition switch is turned off (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>OPERATION CHECK).

Result
Result Proceed to
Driver side door or front passenger side door is opened within 45 sec. but power windows can still operate A
45 sec. pass and power windows can still operate B



A

3.READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY SWITCH)

B

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

3.READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY SWITCH)
a.

Use the Data List to check if the main body ECU is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Driver Door Window Only)>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver door open
OFF: Driver door closed
-
P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger door open
OFF: Front passenger door closed
-

OK:

The display changes according to above chart.




OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

NG

4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
a.

Open the driver side door and check that the map light illuminates (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>OPERATION CHECK).

OK:

Map light illuminates.



b.

Open the front passenger side door and check that the map light illuminates (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>OPERATION CHECK).

OK:

Map light illuminates.




OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

NG

REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY