Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM2660E _59 Vehicle Exterior _052851 SLIDING ROOF / CONVERTIBLE _0255741 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  DISASSEMBLY  


PROCEDURE

Hide 63260A 1.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

a.
B178616

Detach the bracket claw and remove the bracket.


b.
B178617

Remove the 2 bolts, room light bracket and drive gear.


Hide 63306 2.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

U155752E01
0.696,0 1.315,0.181 0.619,0.181 10 Rearward

a.

Remove the 2 screws.


b.

Detach the 4 claws and remove the sliding roof piece LH and RH.


c.

Slide and remove the trim.


Hide 63229A 3.REMOVE SLIDING ROOF SUNSHADE STOPPER LH

a.
B178631

Remove the stopper.


Hide 63229A 4.REMOVE SLIDING ROOF SUNSHADE STOPPER RH

HINT:

Use the same procedures described for the LH side.


Hide 63205A 5.REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:

Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


a.
B178622

Remove the 2 screws and 2 stoppers.


b.
B178623E04
1.25,1.219 1.625,1.427 false 1.052,2.823 1.688,3.094 0.635,0.271 10 true Rearward 0.427,1.115 1.094,1.458 0.667,0.344 10 false Protective Tape

Using a screwdriver, detach the 2 claws slide the rear roof drip channel rearward to remove it.

HINT:

Tape the screwdriver tip before use.



c.
B178618

Hold down the window deflector.


d.
B178626E01
0.848,0.857 1.269,0.186 1.269,0.186 1.487,0.186 false 1.501,0.104 2.391,0.285 0.890,0.181 10 Matchmark A 0.838,1.128 1.371,0.861 1.371,0.861 1.618,0.861 false 1.636,0.776 2.599,0.957 0.963,0.181 10 Matchmark B

Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.


e.
B178619E01
0.102,0.177 1.159,0.388 1.057,0.211 10 Protective Tape 2.046,1.5 1.673,0.275 1.673,0.275 1.32,0.275 false

Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

HINT:

Tape the screwdriver tip before use.