Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM2660E _59 Vehicle Exterior _052851 SLIDING ROOF / CONVERTIBLE _0255741 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  REASSEMBLY  


PROCEDURE

Hide 63205A 1.INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

a.

Hold down the window deflector.

NOTICE:
B178620

Make sure that the spring indicated by the arrow in the illustration is securely installed.



b.
B178624E01
0.538,0.257 1.597,0.476 1.059,0.218 10 Protective Tape 2.839,1.152 2.066,0.348 2.066,0.348 1.77,0.348 false

Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

HINT:

Tape the screwdriver tip before use.



c.
B178625E01
0.735,3.45 1.262,3.632 0.526,0.181 10 Forward

Slide the rear roof drip channel forward and attach the 2 claws to install it.


d.
B178622

Install the 2 stoppers with the 2 screws.


Hide 63205A 2.ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

U155753E01
0.84,0.869 1.269,0.186 1.269,0.186 1.487,0.186 false 2.984,2.647 2.984,1.223 false 2.984,1.223 2.724,1.223 false 2.114,2.637 1.936,2.845 false 1.884,2.649 1.736,2.819 false 0.834,1.134 1.286,0.647 1.286,0.647 1.492,0.647 false 1.501,0.098 2.394,0.270 0.893,0.172 10 Matchmark A 1.501,0.557 2.394,0.729 0.893,0.172 10 Matchmark B 1.529,1.107 2.680,1.344 1.152,0.237 10 Protective Tape

a.

Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

HINT:

Tape the screwdriver tip before use.



Hide 63229A 3.INSTALL SLIDING ROOF SUNSHADE STOPPER LH

a.
B178631

Install the stopper.


Hide 63229A 4.INSTALL SLIDING ROOF SUNSHADE STOPPER RH

HINT:

Use the same procedures described for the LH side.


Hide 63306 5.INSTALL SUNSHADE TRIM SUB-ASSEMBLY

a.
U155774E01
0.696,0 1.222,0.181 0.526,0.181 10 Forward

Insert the sunshade trim into the sliding roof housing.


b.

Attach the 4 claws to install the sliding roof piece LH and RH.


c.

Install the 2 screws.


Hide 63260A 6.INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B178617

a.

Install the drive gear and room light bracket with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.
B178616

Attach the bracket claw to install the bracket.