Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255744 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B057104E38
0.271,1.406 1.406,1.625 1.135,0.219 10 false Centering Bolt 2.177,1.448 3.24,1.677 1.063,0.229 10 false Standard Bolt

HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

a.

Check that the clearance measurements of areas A to C are within the standard range.

B182245E02
1.656,0.156 1.854,0.375 0.198,0.219 10 false A 4.844,0.146 5.042,0.365 0.198,0.219 10 false B 5.302,0.448 5.5,0.667 0.198,0.219 10 false C

Standard Measurement:
Area Specified Condition
A (Reference) 2.3 to 5.3 mm (0.0906 to 0.209 in.)
B 2.0 to 5.0 mm (0.0787 to 0.197 in.)
C -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)



Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.
B182246

Adjust the hood position.

i.

Loosen the 4 hinge bolts of the hood.


ii.

Move the hood and adjust the clearance between the hood and front fender.


iii.

Tighten the 4 hinge bolts of the hood after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


iv.
B182247

Adjust the cushion rubber so that the height of the hood and fender are aligned.

HINT:

Raise or lower the hood front end by turning the cushion rubber.




b.

Adjust the hood lock.

i.
B182248

Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



ii.
B182249

Loosen the 2 bolts and hood lock nut.


iii.

Adjust the hood lock position so that the striker can enter it smoothly.


iv.

Tighten the bolts and nut after the adjustment.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


v.

Install a new cap.