Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255745 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 68961 1.REMOVE HOOD STAY BOLT

a.

Clean the threaded surface on the vehicle body with a non-residue solvent.


b.

When reusing the hood stay bolt:

i.

Clean the threaded surface on the bolt with a non-residue solvent.


ii.

Apply adhesive to the threads of the hood stay bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



iii.

Install the hood stay bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)



Hide 53337C 2.REMOVE HOOD STAY BRACKET LH

a.

Attach the guide to install the hood stay bracket LH with the bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 53450A 3.INSTALL HOOD SUPPORT ASSEMBLY LH

NOTICE:
·

As much as possible, avoid touching the stroke portions of the rod to prevent foreign matter from attaching to them. Be sure to hold the cylinders while servicing.

·

Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any load to the cylinders in the horizontal direction in order to prevent the rod from being deformed.



a.

When Reusing the hood support assembly LH:

i.
B421440

Install the hood support assembly LH with the 2 stop rings.


ii.

Attach the 2 ball joints to install the hood support assembly LH.

NOTICE:
·

Install the hood support assembly LH while supporting the hood by hand.

·

Check that the hood support assembly LH is attached to the ball joint and cannot be pulled out.