84965
1.INSPECT POWER BACK DOOR MAIN SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6(MSE) - 9(MSW) | Not pushed (on) | Below 1 Ω |
| 6(MSE) - 9(MSW) | Pushed (off) | 10 kΩ or higher |
If the result is not as specified, replace the power back door main switch.
Apply battery voltage to the connector and check the LED illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → terminal 8(ILL+)
Battery negative (-) → terminal 7(ILL-) |
Illuminates |
| *a | Component without harness connected
(Power Back Door Main Switch) |
| *b | Not pushed (on) |
| *c | Pushed (off) |