1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64910J
3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
4.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL)
Use the same procedure described for the LH side.
51775
5.REMOVE REAR STEP COVER
67917C
6.REMOVE REAR DOOR SCUFF PLATE RH
58574A
7.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
71845B
8.REMOVE REAR SEAT COVER CAP RH (w/ Rear No. 2 Seat)
62510P
9.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
67939B
10.REMOVE CENTER BACK DOOR GARNISH
67937B
11.REMOVE BACK DOOR SIDE GARNISH RH
67847
12.REMOVE BACK DOOR SERVICE HOLE COVER RH
62471D
13.REMOVE REAR UPPER PILLAR GARNISH RH
68910
14.REMOVE POWER BACK DOOR UNIT ASSEMBLY
Disconnect the connector
Remove the 4 bolts.
Detach the 2 claws and remove the power back door unit assembly.