84931C
1.INSPECT BACK DOOR CONTROL SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 - 4 | Pushed (on) | Below 1 Ω |
| 3 - 4 | Not pushed (off) | 10 kΩ or higher |
If the result is not as specified, replace the back door control switch.
Apply battery voltage to the connector and check the LED illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → terminal 2(ILL+)
Battery negative (-) → terminal 1(ILL-) |
Illuminates |
| *a | Component without harness connected
(Back Door Control Switch) |
| *b | Not pushed (off) |
| *c | Pushed (on) |