Home › Vehicle Exterior › DOOR / HATCH › TAIL GATE CLOSER SYSTEM › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255760 TAIL GATE CLOSER SYSTEM U

DOOR / HATCH  TAIL GATE CLOSER SYSTEM  TERMINALS OF ECU  


CHECK NO. 2 MAIN BODY ECU


U164149E02
3.104,0.354 3.365,0.51 0.26,0.156 10 false L50 4.302,0.354 4.563,0.51 0.26,0.156 10 false L51

a.

Disconnect the L50 and L51 No. 2 main body ECU connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L50-14 (BECU) - Body ground R - Body ground BECU power supply Always 11 to 14 V
L50-13 (SIG) - Body ground B - Body ground SIG power supply Engine switch on (IG) 11 to 14 V
L50-13 (SIG) - Body ground B - Body ground SIG power supply Engine switch off Below 1 V
L51-5 (B) - Body ground LA-B - Body ground Lower tail gate lock motor RH power supply Always 11 to 14 V
L51-6 (B) - Body ground LA-W - Body ground Lower tail gate lock motor LH power supply Always 11 to 14 V
L50-7 (GND) - Body ground W-B - Body ground Body ground Always Below 1 Ω
L51-7 (GND) - Body ground W-B - Body ground Body ground Always Below 1 Ω
L50-19 (BDSU) - Body ground V - Body ground Back door remote control signal circuit Back door remote control pulled (on) Below 1 Ω
L50-19 (BDSU) - Body ground V - Body ground Back door remote control signal circuit Back door remote control free (off) 10 kΩ or higher

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the L50 and L51 No. 2 main body ECU connectors.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L51-3 (DC+) - L51-7 (GND) R - W-B Lower tail gate lock motor LH circuit Lower tail gate lock motor LH operating (close) 11 to 14 V
L51-3 (DC+) - L51-7 (GND) R - W-B Lower tail gate lock motor LH circuit Lower tail gate lock motor LH stopped Below 1 V
L51-8 (DC-) - L51-7 (GND) B - W-B Lower tail gate lock motor LH circuit Lower tail gate lock motor LH operating (open) 11 to 14 V
L51-8 (DC-) - L51-7 (GND) B - W-B Lower tail gate lock motor LH circuit Lower tail gate lock motor LH stopped Below 1 V
L51-2 (DC+) - L51-7 (GND) G - W-B Lower tail gate lock motor RH circuit Lower tail gate lock motor RH operating (close) 11 to 14 V
L51-2 (DC+) - L51-7 (GND) G - W-B Lower tail gate lock motor RH circuit Lower tail gate lock motor RH stopped Below 1 V
L51-1 (DC-) - L51-7 (GND) W - W-B Lower tail gate lock motor RH circuit Lower tail gate lock motor RH operating (open) 11 to 14 V
L51-1 (DC-) - L51-7 (GND) W - W-B Lower tail gate lock motor RH circuit Lower tail gate lock motor RH stopped Below 1 V
L51-9 (HAF) - L51-7 (GND) GR - W-B Half-latch switch LH signal circuit Lower tail gate open Below 1 V
L51-9 (HAF) - L51-7 (GND) GR - W-B Half-latch switch LH signal circuit Lower tail gate closed Pulse generation
(See waveform 1)
L50-8 (HAF) - L51-7 (GND) B - W-B Half-latch switch RH signal circuit Lower tail gate open Below 1 V
L50-8 (HAF) - L51-7 (GND) B - W-B Half-latch switch RH signal circuit Lower tail gate closed Pulse generation
(See waveform 1)
L51-4 (FUL) - L51-7 (GND) G - W-B Lower tail gate courtesy switch LH signal circuit Lower tail gate open Below 1 V
L51-4 (FUL) - L51-7 (GND) G - W-B Lower tail gate courtesy switch LH signal circuit Lower tail gate closed Pulse generation
(See waveform 1)
L50-22 (FUL) - L51-7 (GND) P - W-B Lower tail gate courtesy switch RH signal circuit Lower tail gate open Below 1 V
L50-22 (FUL) - L51-7 (GND) P - W-B Lower tail gate courtesy switch RH signal circuit Lower tail gate closed Pulse generation
(See waveform 1)
L51-10 (LMT) - L51-7 (GND) P - W-B Close position switch LH signal circuit Lower tail gate closed Below 1 V
L51-10 (LMT) - L51-7 (GND) P - W-B Close position switch LH signal circuit Lower tail gate open Pulse generation
(See waveform 2)
L50-17 (LMT) - L51-7 (GND) L - W-B Close position switch RH signal circuit Lower tail gate closed Below 1 V
L50-17 (LMT) - L51-7 (GND) L - W-B Close position switch RH signal circuit Lower tail gate open Pulse generation
(See waveform 2)
L50-15 (POL) - L51-7 (GND) L - W-B Pawl switch LH signal circuit Lower tail gate lock motor LH is operating Below 1 V
L50-15 (POL) - L51-7 (GND) L - W-B Pawl switch LH signal circuit Lower tail gate open Pulse generation
(See waveform 2)
L50-16 (POL) - L51-7 (GND) R - W-B Pawl switch RH signal circuit Lower tail gate lock motor RH is operating Below 1 V
L50-16 (POL) - L51-7 (GND) R - W-B Pawl switch RH signal circuit Lower tail gate open Pulse generation
(See waveform 2)
L50-19 (BDSU) - L51-7 (GND) V - W-B Back door remote control signal circuit Back door remote control pulled (on) Below 1 V
L50-19 (BDSU) - L51-7 (GND) V - W-B Back door remote control signal circuit Back door remote control free (off) Pulse generation
(See waveform 3)


e.
B197194E01
2.796,0.997 3.129,1.149 0.333,0.152 10 GND

Using an oscilloscope, check waveform 1.

Waveform 1 (Reference)
Item Content
Terminal (Symbol)
·

L51-9 (HAF) - L51-7 (GND)

·

L50-8 (HAF) - L51-7 (GND)

·

L51-4 (FUL) - L51-7 (GND)

·

L50-22 (FUL) - L51-7 (GND)


Tool Setting 5 V/DIV., 5 ms/DIV
Condition Lower tail gate closed


f.
B197195E01
2.796,1.019 3.129,1.161 0.333,0.142 10 GND

Using an oscilloscope, check waveform 2.

Waveform 2 (Reference)
Item Content
Terminal (Symbol)
·

L51-10 (LMT) - L51-7 (GND)

·

L50-17 (LMT) - L51-7 (GND)

·

L51-15 (POL) - L51-7 (GND)

·

L50-16 (POL) - L51-7 (GND)


Tool Setting 5 V/DIV., 5 ms/DIV
Condition Lower tail gate open


g.
B197194E01
2.796,0.997 3.129,1.149 0.333,0.152 10 GND

Using an oscilloscope, check waveform 3.

Waveform 3 (Reference)
Item Content
Terminal (Symbol) L50-19 (BDSU) - L51-7 (GND)
Tool Setting 5 V/DIV., 5 ms/DIV
Condition Back door remote control free (off)