Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255761 POWER BACK DOOR SYSTEM D

DOOR / HATCH  POWER BACK DOOR SYSTEM  INITIALIZATION  


RESET BACK DOOR CLOSE POSITION


NOTICE:

Perform initialization of the power back door system (power back door unit assembly [power back door ECU] initialization) if one of the following is performed: 1) The cable is disconnected from the negative (-) battery terminal; 2) a wire harness, the power back door unit assembly (power back door ECU) or back door lock assembly is replaced or removed/installed; or 3) the ECU-B2 fuse is replaced or removed/installed. If initialization is not performed, the power back door system will not operate.


a.

When the back door is open and the cable is disconnected and reconnected to the negative (-) battery terminal, fully close the back door by hand.

HINT:

Initialization is not necessary if the cable is disconnected and reconnected to the negative (-) battery terminal while the back door is closed. However, because the power back door unit assembly [power back door ECU] recognizes that the back door is locked, the power back door system will not operate if the back door is not unlocked.




CHECK POWER BACK DOOR FUNCTION


HINT:
·

If the power back door system does not operate and/or the back door does not open, disconnect the cable from the negative (-) battery terminal. Then wait 10 seconds, reconnect the cable and perform initialization of the power back door system again.