Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255761 POWER BACK DOOR SYSTEM J

DOOR / HATCH  POWER BACK DOOR SYSTEM  Power Back Door Opener / Closer Switch Circuit  


DESCRIPTION

The door control switch only turns on while the switch is being pressed, and turns off when the switch is released.

When the switch is on, a power back door operation request signal is input to the main body ECU (cowl side junction block LH) to operate the back door.

WIRING DIAGRAM

B312261E02
5.413,1.611 6.037,1.754 0.624,0.143 10 E2 5.721,0.724 5.831,0.867 0.111,0.143 10 2 5.934,0.836 6.558,0.979 0.624,0.143 10 PBDS 2.661,0.724 3.285,0.867 0.624,0.143 10 6 2.223,0.836 2.584,0.979 0.361,0.143 10 CSW 1.621,0.724 1.716,0.867 0.095,0.143 10 3 1.814,0.836 1.926,0.979 0.112,0.143 10 E 1.569,1.263 2.193,1.406 0.624,0.143 10 E105 1.569,1.401 2.831,1.571 1.262,0.169 10 Door Control Switch 5.413,1.751 7.156,2.089 1.743,0.338 10 Main Body ECU (Cowl Side Junction Block LH)

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (BACK DOOR OPEN SW)
a.

Check the Data List for proper functioning of the door control switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Back Door Open SW Door control switch signal / ON or OFF ON: Door control switch on
OFF: Door control switch off
-

OK:

The display is as specified in the normal condition.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT DOOR CONTROL SWITCH
2.INSPECT DOOR CONTROL SWITCH
a.

b.


OK

3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH] AND BODY GROUND)

NG

3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH] AND BODY GROUND)
a.

Disconnect the E105 door control switch connector.


b.

Disconnect the E2 main body ECU (cowl side junction block LH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E105-6 (CSW) - E2-2 (PBDS) Always Below 1 Ω
E105-3 (E) - Body ground Always Below 1 Ω
E105-6 (CSW) - Body ground Always 10 kΩ or higher




OK

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR