Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM(w/o Rain Sensor) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255770 WIPER AND WASHER SYSTEM(w/o Rain Sensor) U

WIPER / WASHER  WIPER AND WASHER SYSTEM(w/o Rain Sensor)  TERMINALS OF ECU  


CHECK HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)


E139344

HINT:

The headlight cleaner control relay uses waterproof connector. Therefore, voltage cannot be checked with the connector connected to the vehicle.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
3 (IG) - 4 (E) - IG signal circuit Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
4 (E) - Body ground - Ground circuit Always Below 1 Ω
6 (PB) - 4 (E) - Headlight cleaner motor operation signal Headlight cleaner motor is stopped 11 to 14 V
Headlight cleaner motor is operating Below 1 V
2 (H) - 4 (E) - Headlight cleaner switch and headlight switch operation signal Ignition switch ON
Headlight cleaner switch is off
Below 1 V
Ignition switch ON
Headlight switch is off
Below 1 V
Ignition switch ON
Headlight cleaner switch is on and headlight dimmer switch in HEAD
11 to 14 V
5 (FRWA) - 4 (E)* - Front washer switch operation signal Ignition switch ON
Front washer switch is off
11 to 14 V
Ignition switch ON
Front washer switch is on
Below 1 V
1 (HDLO) - 4 (E)* - Headlight low beam operation signal Ignition switch ON
Headlight dimmer switch in HEAD
11 to 14 V
Ignition switch ON
Headlight dimmer switch not in HEAD
Below 1 V

*: w/ Headlight Auto Leveling



NO. 2 MULTIPLEX NETWORK BODY ECU (w/ Washer Nozzle Heater System)


U164149E03
3.125,0.344 3.385,0.5 0.26,0.156 10 false L50 4.344,0.344 4.604,0.5 0.26,0.156 10 false L51

a.

Disconnect the L50 and L51 No. 2 multiplex network body ECU connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L50-14 (BECU) - Body ground R - Body ground Power source circuit Always 11 to 14 V
L50-13 (SIG) - Body ground G - Body ground IG signal circuit Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
L50-7 (GND) - Body ground W-B - Body ground Ground circuit Always Below 1 Ω


c.

Reconnect the L50 and L51 No. 2 multiplex network body ECU connectors.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
L50-25 (WHTR) - Body ground GR - Body ground Washer nozzle heater signal circuit Ignition switch ON, ambient temperature 6°C (42°F) or higher 11 to 14 V
Ignition switch ON, ambient temperature 5°C (41°F) or less Below 1 V