Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255772 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for LHD, for RHD LH Side)

a.

w/o Rain Sensor

Check the front wiper intermittent operation.

i.
U156632E01
0.071,0.027 0.268,0.211 0.198,0.184 10 *a 0.264,1.185 0.565,1.347 0.301,0.163 10 E16 0.752,0.474 0.959,0.637 0.208,0.163 10 +1 2.898,1.185 3.197,1.347 0.299,0.163 10 E15 1.171,1.08 0.901,0.655 false 2.426,1.839 2.739,2.002 0.313,0.163 10 EW 2.46,1.391 2.554,1.823 false

Connect a voltmeter positive (+) lead to terminal E16-3 (+1) and a negative (-) lead to terminal E15-4 (EW).

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)


ii.

Turn the wiper switch to the INT position.


iii.

Operate the intermittent wiper relay and check the voltage between terminals E16-3 (+1) and E15-4 (EW).

OK:

Voltage changes as shown in the illustration.


U165966E01
0.081,1.562 1.980,1.889 1.899,0.327 10 Voltage between terminals E16-3 (+1) and E15-4 (EW) 1.682,1.173 2.402,1.324 0.719,0.151 10 11 to 14 V 2.148,1.651 2.422,1.807 0.274,0.156 10 0 V 2.432,2.086 3.497,2.250 1.064,0.164 10 1.6 +/-1 second 2.754,0.454 4.743,0.804 1.989,0.350 10 FAST: Connect battery negative (-) lead to terminal E16-1 (+S) 4.847,0.454 7.120,0.804 2.273,0.351 10 SLOW: Connect battery negative (-) lead to terminal E16-1 (+S) 4.573,2.078 5.766,2.233 1.193,0.155 10 10.7 +/-5 seconds 4.761,1.969 4.761,1.758 false 3.122,1.758 3.122,1.969 false 4.761,1.967 5.56,1.967 false 2.73,1.969 3.122,1.969 false 2.73,2.039 2.73,1.969 false 2.73,1.969 2.73,1.758 false 2.73,0.918 2.73,1.266 false 3.122,2.039 3.122,1.969 false 3.122,1.969 3.122,1.758 false 4.761,1.969 4.761,1.758 false 4.759,0.918 4.759,1.266 false 4.761,2.039 4.761,1.969 false 5.56,2.039 5.56,1.969 false 5.56,1.969 5.56,1.758 false 0.04,0.007 2.439,0.239 2.399,0.232 12 w/ Intermittent Time Adjust Dial:

B278090E07
0.083,0.646 2.021,1.104 1.938,0.458 10 false Voltage between terminals E16-3 (+1) and E15-4 (EW) 3.854,0.063 5.938,0.521 2.083,0.458 10 false Connect battery negative (-) lead to terminal E16-1 (+S) 3.698,1.302 4.844,1.563 1.146,0.26 10 false 3.3 +/- 1 second 2.708,0.479 3.5,0.74 0.792,0.26 10 false 11 to 14 V 3.115,0.865 3.438,1.125 0.323,0.26 10 false 0 V 0.042,0.052 2.563,0.292 2.521,0.24 12 false w/o Intermittent Time Adjust Dial:

If the result is not as specified, replace the windshield wiper switch assembly.



b.

Check the front washer operation.

i.
U156633E01
0.071,0.027 0.268,0.211 0.198,0.184 10 *a 0.264,1.185 0.565,1.347 0.301,0.163 10 E16 1.671,1.892 2.066,2.055 0.395,0.163 10 WF 2.898,1.185 3.197,1.347 0.299,0.163 10 E15 1.803,1.845 2.074,1.42 false 2.426,1.839 2.739,2.002 0.313,0.163 10 EW 2.46,1.391 2.554,1.823 false

Connect a voltmeter positive (+) lead to terminal E15-7 (WF) and a negative (-) lead to terminal E15-4 (EW).

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)


ii.

Turn the power switch on (IG).


iii.

Turn the washer switch on and off, and check the voltage between terminals E15-7 (WF) and E15-4 (EW).

OK:

Voltage changes as shown in the following illustration.


E157493E13
0.643,0.921 2.509,1.415 1.867,0.494 10 Voltage between terminals E15-7 (WF) and E15-4 (EW) 1.829,0.403 2.784,0.559 0.955,0.156 10 Washer Switch 3.417,1.166 3.781,1.322 0.364,0.156 10 0 V 3.137,0.896 3.827,1.037 0.691,0.142 10 11 to 14 V 2.819,1.474 4.545,1.616 1.725,0.142 10 Approximately 0.5 seconds 4.671,1.481 6.396,1.623 1.725,0.142 10 Approximately 2.2 seconds 4.034,1.355 3.991,1.467 false 4.692,1.348 4.839,1.46 false 3.417,0.564 3.781,0.720 0.364,0.156 10 OFF 3.48,0.279 3.754,0.435 0.274,0.156 10 ON 5.029,0.077 6.755,0.219 1.725,0.142 10 Approximately 1.5 seconds 5,0.149 4.429,0.149 4.429,0.149 4.228,0.268 false

If the result is not as specified, replace the windshield wiper switch assembly.



Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for RHD RH Side)

a.

w/o Rain Sensor

Check the front wiper intermittent operation.

i.
U166467E02
2.167,1.156 2.438,0.74 false 1.01,1.469 0.917,1.771 false 0.094,0.01 0.292,0.198 0.198,0.188 10 false *a 2.813,1.177 3.115,1.344 0.302,0.167 10 false E16 2.406,0.552 2.615,0.719 0.208,0.167 10 false +1 0.333,1.198 0.635,1.365 0.302,0.167 10 false E15 0.792,1.792 1.104,1.958 0.313,0.167 10 false EW

Connect a voltmeter positive (+) lead to terminal E16-2 (+1) and a negative (-) lead to terminal E15-7 (EW).

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)


ii.

Turn the wiper switch to the INT position.


iii.

Operate the intermittent wiper relay and check the voltage between terminals E16-2 (+1) and E15-7 (EW).

OK:

Voltage changes as shown in the illustration.


U165967E01
0.081,1.562 1.980,1.889 1.899,0.327 10 Voltage between terminals E16-2 (+1) and E15-7 (EW) 1.682,1.173 2.402,1.324 0.719,0.151 10 11 to 14 V 2.148,1.651 2.422,1.807 0.274,0.156 10 0 V 2.432,2.086 3.497,2.250 1.064,0.164 10 1.6 +/-1 second 2.754,0.454 4.743,0.804 1.989,0.350 10 FAST: Connect battery negative (-) lead to terminal E16-1 (+S) 4.847,0.454 7.120,0.804 2.273,0.351 10 SLOW: Connect battery negative (-) lead to terminal E16-1 (+S) 4.573,2.078 5.766,2.233 1.193,0.155 10 10.7 +/-5 seconds 4.761,1.969 4.761,1.758 false 3.122,1.758 3.122,1.969 false 4.761,1.967 5.56,1.967 false 2.73,1.969 3.122,1.969 false 2.73,2.039 2.73,1.969 false 2.73,1.969 2.73,1.758 false 2.73,0.918 2.73,1.266 false 3.122,2.039 3.122,1.969 false 3.122,1.969 3.122,1.758 false 4.761,1.969 4.761,1.758 false 4.759,0.918 4.759,1.266 false 4.761,2.039 4.761,1.969 false 5.56,2.039 5.56,1.969 false 5.56,1.969 5.56,1.758 false 0.04,0.007 2.439,0.239 2.399,0.232 12 w/ Intermittent Time Adjust Dial:

B278090E08
0.083,0.49 2.021,0.948 1.938,0.458 10 false Voltage between terminals E16-2 (+1) and E15-7 (EW) 3.854,0.052 5.938,0.51 2.083,0.458 10 false Connect battery negative (-) lead to terminal E16-1 (+S) 3.698,1.313 4.844,1.573 1.146,0.26 10 false 3.3 +/- 1 second 2.698,0.479 3.49,0.74 0.792,0.26 10 false 11 to 14 V 3.115,0.896 3.438,1.156 0.323,0.26 10 false 0 V 0.042,0 2.563,0.24 2.521,0.24 12 false w/o Intermittent Time Adjust Dial:

If the result is not as specified, replace the windshield wiper switch assembly.



b.

Check the front washer operation.

i.
U166468E02
1.052,1.5 0.958,1.802 false 1.438,1.5 1.531,1.802 false 0.094,0.01 0.292,0.198 0.198,0.188 10 false *a 2.813,1.167 3.115,1.333 0.302,0.167 10 false E16 1.427,1.875 1.802,2.042 0.375,0.167 10 false WF 0.344,1.188 0.646,1.354 0.302,0.167 10 false E15 0.823,1.865 1.135,2.031 0.313,0.167 10 false EW

Connect a voltmeter positive (+) lead to terminal E15-7 (WF) and a negative (-) lead to terminal E15-4 (EW).

Text in Illustration
*a Component with harness connected
(Windshield Wiper Switch Assembly)


ii.

Turn the power switch on (IG).


iii.

Turn the washer switch on and off, and check the voltage between terminals E15-4 (WF) and E15-7 (EW).

OK:

Voltage changes as shown in the following illustration.


E226602E29
4.094,1.333 4.021,1.5 false 4.76,1.333 4.844,1.51 false 0.969,0.823 2.625,1.375 1.656,0.552 10 false Voltage between terminals I32-3 (+1) and I31-7 (EW): 1.677,0.208 2.667,0.542 0.99,0.333 10 false Washer Switch: 2.49,1.5 4.49,1.75 2,0.25 10 false Approximately 0.5 seconds 4.573,1.49 6.51,1.75 1.938,0.26 10 false Approximately 2.2 seconds 2.958,0.792 3.792,1.156 0.833,0.365 10 false 11 to 14 V 3.375,1.135 3.833,1.542 0.458,0.406 10 false 0 V 3.302,0.438 3.813,0.833 0.51,0.396 10 false OFF 3.344,0.219 3.74,0.552 0.396,0.333 10 false ON

If the result is not as specified, replace the windshield wiper switch assembly.