Home › Vehicle Exterior › WIPER / WASHER › RELAY(w/ Headlight Cleaner System) › from 2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255779 RELAY(w/ Headlight Cleaner System) G

WIPER / WASHER  RELAY(w/ Headlight Cleaner System)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

a.
E186708E12
0.927,1.667 1.229,1.417 false 1.542,0.885 1.51,0.344 1.51,0.344 1.594,0.333 false 1.229,0.875 0.844,0.677 false 2.25,1.667 2.021,1.427 false 0.135,0.135 0.448,0.333 0.313,0.198 10 false *a 0.646,0.531 0.958,0.729 0.313,0.198 10 false IG 1.625,0.25 1.938,0.448 0.313,0.198 10 false H 0.771,1.646 1.083,1.844 0.313,0.198 10 false B 2.313,1.646 2.625,1.844 0.313,0.198 10 false E

w/o Washer Linked Operation:

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (B) - 4 (E) Battery voltage is not applied between terminals 3 (IG) and 2 (H) 10 kΩ or higher
Battery voltage is applied between terminals 3 (IG) and 2 (H) Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)


If the result is not as specified, replace the headlight cleaner control relay.

Text in Illustration
*a Component without harness connected
(Headlight Cleaner Control Relay)



b.
E186708E08
1.667,0.344 1.594,0.344 1.594,0.344 1.594,0.792 false 2.073,0.969 2.563,0.875 false 2.052,1.438 2.552,1.708 false 0.76,0.573 1.26,0.844 false 1.667,1.76 1.656,1.448 false 0.813,1.667 1.25,1.458 false 1.74,0.26 1.896,0.458 0.156,0.198 10 false H 2.625,1.646 2.781,1.844 0.156,0.198 10 false E 0.573,0.438 0.844,0.635 0.271,0.198 10 false IG 0.573,1.625 0.844,1.823 0.271,0.198 10 false PB 0.073,0.083 0.344,0.281 0.271,0.198 10 false *a 2.635,0.802 3.104,0.99 0.469,0.188 10 false HDLO 1.49,1.781 2,1.969 0.51,0.188 10 false FRWA

w/ Washer Linked Operation:

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (B) - 4 (E) Battery voltage not applied 10 kΩ or higher
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 2 (H)
Battery negative (-) → Terminal 4 (E)
Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 1 (HDLO)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)


If the result is not as specified, replace the headlight cleaner control relay.

Text in Illustration
*a Component without harness connected
(Headlight Cleaner Control Relay)