Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR › from 2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255782 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

HINT:

Rain sensor tape is reusable. Only replace the rain sensor tape if it is damaged or contaminated.


a.

Clean the sensing portion of the rain sensor with a piece of cloth, etc.


b.
E220066E01
2.137,1.597 2.796,1.597 false 2.82,1.508 2.975,1.654 0.156,0.147 10 *1 1.305,2.93 1.433,3.086 0.128,0.156 10 B 0.544,2.148 0.673,2.304 0.128,0.156 10 A

Peel off the smaller release sheet, and then attach the rain sensor tape to the sensing portion of the rain sensor as shown in the illustration.

Standard Clearance
Area Measurement
A 13.5 mm (0.532 in.)
B 7.25 mm (0.285 in.)

Text in Illustration
*1 Rain Sensor Tape

NOTICE:

Use your fingers to push out any air bubbles from under the rain sensor tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth, etc.

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




b.

When installing a new rain sensor or replacing the rain sensor tape:.

i.

Peel off the release sheet.

HINT:

Do not touch the silicon coated surfaces.




c.
U155946E01
0.149,1.407 0.399,1.653 0.250,0.246 10 *a 0.501,0.148 0.751,0.394 0.250,0.246 10 *b 0.347,1.51 0.995,1.622 false

Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that air bubbles do not form between the contact surfaces.

Text in Illustration
*a Stopper
*b Guide
V100135

Lock
V100136

Install

NOTICE:

Do not touch the silicon coated or glass surfaces.



d.

Push in the stopper.


e.
B427841

Connect the connector.


Hide 89943 3.INSTALL RAIN SENSOR COVER

a.
B427842

Attach the 2 claws to install the rain sensor cover.


b.
B427843

Slide the rain sensor cover to attach the 2 guides.