Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255782 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT FUNCTION OF RAIN SENSOR

E157938E06
5.583,0.542 5.25,1.354 false 4.771,1.729 4.063,2.188 false 5.625,0.458 6.938,0.635 1.313,0.177 10 false Rain Sensor Center 3.24,2.125 4.26,2.469 1.021,0.344 10 false Rain Sensor Detection Area 5.958,2.073 6.531,2.25 0.573,0.177 10 false Unit: mm 4.302,1.031 4.438,1.198 0.135,0.167 10 false A 4.354,1.563 4.49,1.729 0.135,0.167 10 false A 4.833,2.188 4.969,2.354 0.135,0.167 10 false B 5.521,2.177 5.656,2.344 0.135,0.167 10 false B 4.76,0.656 4.896,0.823 0.135,0.167 10 false C 4.896,0.344 5.031,0.51 0.135,0.167 10 false D 6.615,1.125 6.75,1.292 0.135,0.167 10 false E 6.615,1.469 6.75,1.635 0.135,0.167 10 false E

a.

LO operation inspection

i.

Turn the engine switch on (IG), and set the windshield wiper switch to AUTO.


ii.

Flatten the end of a cotton swab soaked with water so that it is 4 to 6 mm (0.157 to 0.236 in.) wide.


iii.

Wipe the cotton swab in the center of the rain sensor detection area (within the range shown in the illustration), and check that the wiper operates once.



b.

HI operation inspection

i.

Cut 2 or 3 squares out of tissue paper so that they are 25 mm (0.984 in.) long on each side, and soak them with water.


ii.

Jack up the vehicle.


iii.

Depress the accelerator pedal so that the wheel speed is at 30 km/h (19 mph).


iv.

Place the wet tissue paper onto the rain sensor detection area so that the area is completely covered, and check that the wiper operates on HI.