Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR › from 2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255782 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E169141E31
0.289,0.32 0.542,0.525 0.253,0.205 10 *a 0.881,1.699 1.108,1.848 0.227,0.149 10 ES 2.455,1.715 2.719,1.868 0.264,0.152 10 SIG 2.046,2.454 2.563,1.911 false 1.59,2.427 1.066,1.86 false

Disconnect the rain sensor connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
4 (SIG) - Body ground Power switch on (IG) 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Rain Sensor)

If the result is not as specified, repair or replace the harness or connector.


d.
E141656E37
0.317,0.234 0.549,0.422 0.232,0.188 10 *a 2.195,1.37 2.629,1.522 0.434,0.152 10 MPX 1.539,1.224 1.807,1.376 0.268,0.152 10 ES 1.976,1.981 2.29,1.564 false 1.692,1.417 1.809,1.981 false

Reconnect the rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
1 (MPX) - 2 (ES) Power switch on (IG) Pulse generation


Text in Illustration
*a Component with harness connected
(Rain Sensor)

If the result is not as specified, the rain sensor may have a malfunction.