Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255783 REAR WIPER MOTOR G

WIPER / WASHER  REAR WIPER MOTOR  INSPECTION  


PROCEDURE

Hide 85110R 1.INSPECT REAR WIPER MOTOR ASSEMBLY

a.
B106251E11
2.862,1.342 3.004,1.503 0.142,0.161 10 E 0.438,1.331 0.613,1.477 0.174,0.147 10 W 1.645,1.944 1.835,2.090 0.191,0.147 10 LS 2.138,0.326 2.262,0.482 0.124,0.156 10 B 1.121,0.322 1.338,0.464 0.216,0.142 10 C1 2.292,1.422 2.836,1.422 false 0.641,1.422 1.186,1.422 false 1.731,1.568 1.731,1.926 false 1.505,1.274 1.505,0.406 1.505,0.406 1.368,0.406 false 1.977,1.274 1.977,0.406 1.977,0.406 2.114,0.406 false 0.037,0.036 0.230,0.182 0.193,0.147 10 *a

Check the wiper operation.

i.

Apply battery voltage to the rear wiper motor and check the rear wiper motor operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (B)
Battery negative (-) → Terminal 3 (LS) and Terminal 5 (E)
Motor operates continuously


If the result is not as specified, replace the rear wiper motor assembly.



b.

Check the INT operation.

i.

Apply battery voltage to the rear wiper motor and check the rear wiper motor operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (B)
Battery negative (-) → Terminal 2 (C1) and Terminal 5 (E)
Motor operates intermittently


If the result is not as specified, replace the rear wiper motor assembly.



c.

Check the rear washer linked operation.

i.

Apply battery voltage to the rear wiper motor and check the rear wiper motor operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (B)
Battery negative (-) → Terminal 1 (W) and Terminal 5 (E)
Motor operates


If the result is not as specified, replace the rear wiper motor assembly.



d.

Check the automatic stop position operation.

i.

Connect the battery positive (+) lead to terminal 4 (B), and the negative (-) lead to terminal 3 (LS) and terminal 5 (E). With the motor rotating, disconnect terminal 3 (LS) to stop the wiper motor operation at any position other than the matchmark.


ii.

Check that the motor stops automatically at the matchmark.

OK:

Motor stops automatically at the matchmark.


If the result is not as specified, replace the rear wiper motor assembly.