85143R
1.INSTALL REAR WIPER MOTOR GROMMET
Apply MP grease to the entire inner surface of the rear wiper motor grommet.
| *1 | MP Grease |
Make sure that the hole does not get clogged with grease and the grooves in the grommet are filled with grease.
Install the rear wiper motor grommet.
| *1 | Position Mark |
| *a | Upward |
Install the grommet with its position mark facing up.
85110R
2.INSTALL REAR WIPER MOTOR ASSEMBLY
Temporarily install the rear wiper motor assembly with the 3 bolts.
Tighten the 3 bolts.
Connect the connector.
3.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
Clean the wiper arm serrations.
| *1 | Wiper Arm Serrations |
| *2 | Wire Brush |
| *3 | Wiper Pivot Serrations |
Clean the wiper pivot serrations with a wire brush.
Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.
Align the tips of the blade with the marks as shown in the illustration.
| *1 | Mark for Blade Position |
Install the rear wiper arm and blade assembly with the nut.
Close the wiper arm head cap.
64780C
4.INSTALL BACK DOOR TRIM PANEL ASSEMBLY RH
64791C
5.INSTALL BACK DOOR TRIM COVER RH
74611B
6.INSTALL ASSIST GRIP RH