85397
1.INSPECT LEVEL WARNING SWITCH ASSEMBLY
The following check should be performed with the windshield washer motor and pump installed to the washer jar.
Fill the washer jar with washer fluid.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Fluid volume is more than 500 to 900 ml | 10 kΩ or higher |
| Fluid volume is less than 500 to 900ml | Below 1 Ω |
| *a | Component without harness connected
(Level Warning Switch Assembly) |
If the result is not as specified, replace the level warning switch assembly.