Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY(for HID Headlight) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255792 HEADLIGHT ASSEMBLY(for HID Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for HID Headlight)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81108 1.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

a.
E247039

Disconnect the connector.


b.

Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly LH.

NOTICE:
·

Do not apply excessive force using a tool.

·

Do not damage the headlight gasket or allow it to become contaminated with foreign matter. If the headlight gasket is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly LH.




c.
E247040

Turn the headlight light control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly LH socket to remove the headlight light control ECU sub-assembly LH.

NOTICE:

Do not pull the headlight light control ECU sub-assembly LH with the socket connected.



Hide 81134 2.REMOVE HEADLIGHT GASKET

a.

Remove the headlight gasket from the headlight light control ECU sub-assembly LH.


Hide 81110L 3.REMOVE DISCHARGE HEADLIGHT BULB

a.
E247041

Release the set spring lock as shown in the illustration and remove the discharge headlight bulb.

NOTICE:

Do not touch the glass part of the discharge headlight bulb.



Hide 81110B 4.REMOVE NO. 1 HEADLIGHT BULB

a.
E244767

Disconnect the connector.


b.

Turn the No. 1 headlight bulb in the direction indicated by the arrow in the illustration and remove the No. 1 headlight bulb.

NOTICE:

Do not touch the glass part of the No. 1 headlight bulb.



Hide 81510C 5.REMOVE FRONT TURN SIGNAL LIGHT BULB

a.
E244768

Turn the socket in the direction indicated by the arrow in the illustration and remove the socket.


b.

Remove the front turn signal light bulb from the socket.


Hide 85662 6.REMOVE HEADLIGHT LEVELING MOTOR LH

a.

Type 1:

i.
E247042E01
2.357,0.029 2.544,0.210 0.187,0.181 10 (1) 1.255,0.99 1.442,1.172 0.187,0.181 10 (2) 1.857,1.574 2.044,1.755 0.187,0.181 10 (3)

Disconnect the connector.


ii.

Turn the motor in the direction indicated by the arrow (1) in the illustration to disconnect it.


iii.

Turn the aiming screw in the direction indicated by the arrow (2) in the illustration to disconnect the shaft.


iv.

Pull the headlight leveling motor LH in the direction indicated by the arrow (3) in the illustration to remove it.



b.

Type 2:

i.
E247911

Align the notches of the headlight leveling motor and the housing, and pull out the headlight leveling motor slightly.

HINT:

For the headlight leveling motor RH, rotate it symmetrical to the directional arrow shown in the illustration.



ii.
E247912

Pull the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.