Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY(for HID Headlight) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255792 HEADLIGHT ASSEMBLY(for HID Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for HID Headlight)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 85662 1.INSTALL HEADLIGHT LEVELING MOTOR LH

a.

Type 1:

i.
E247043E01
1.855,1.575 2.042,1.756 0.187,0.181 10 (1) 1.259,0.941 1.446,1.122 0.187,0.181 10 (2) 2.35,0.051 2.536,0.232 0.187,0.181 10 (3)

Insert the headlight leveling motor LH in the direction indicated by the arrow (1) in the illustration.


ii.

Turn the aiming screw in the direction indicated by the arrow (2) in the illustration to connect the shaft.


iii.

Turn the headlight leveling motor LH in the direction indicated by the arrow (3) in the illustration to install it.


iv.

Connect the connector.



b.

Type 2:

i.
E247913

Attach the tip of the headlight leveling motor LH with the reflector as shown in the illustration.


ii.
E247914

Turn the headlight leveling motor LH in the direction indicated by the arrow in the illustration to install the headlight leveling motor LH.

HINT:

For the headlight leveling motor RH, rotate it in the opposite direction of the arrow shown in the illustration before pulling it out.




Hide 81510C 2.INSTALL FRONT TURN SIGNAL LIGHT BULB

a.
E244771

Install the front turn signal light bulb to the socket.


b.

Turn the socket in the direction indicated by the arrow in the illustration to install the socket.


Hide 81110B 3.INSTALL NO. 1 HEADLIGHT BULB

a.
E244772

Turn the No. 1 headlight bulb in the direction indicated by the arrow in the illustration to install the No. 1 headlight bulb.

NOTICE:

Do not touch the glass port of the No. 1 headlight bulb.



b.

Connect the connector.


Hide 81110L 4.INSTALL DISCHARGE HEADLIGHT BULB

a.
E247044

Install the discharge headlight bulb and lock the set spring as shown in the illustration.

NOTICE:

Do not touch the glass port of the discharge headlight bulb.



Hide 81134 5.INSTALL HEADLIGHT GASKET

a.

Install a new headlight gasket to the headlight light control ECU sub-assembly LH.


Hide 81108 6.INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

a.
E247045

Turn the headlight light control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly LH socket.

NOTICE:
·

Check that the headlight gasket is installed on the headlight light control ECU subassembly LH.

·

Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

·

Do not pull the headlight light control ECU sub-assembly LH with the socket connected.




b.
E247046

Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to install the headlight light control ECU sub-assembly to the headlight unit.


c.

Connect the connector.