Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255793 HIGH INTENSITY DISCHARGE HEADLIGHT BULB A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81110L 1.INSTALL DISCHARGE HEADLIGHT BULB

a.
E247044

Install the discharge headlight bulb and lock the set spring as shown in the illustration.

NOTICE:

Do not touch the discharge headlight bulb glass.



Hide 81134 2.INSTALL HEADLIGHT GASKET

a.

Install a new headlight gasket to the headlight light control ECU sub-assembly LH.


Hide 81108 3.INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

a.
E247045

Turn the headlight light control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly LH socket.

NOTICE:
·

Check that the headlight gasket is installed on the headlight light control ECU subassembly LH.

·

Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

·

Do not pull the headlight light control ECU sub-assembly LH with the socket connected.




b.
E247046

Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to install the headlight unit.


c.

Connect the connector.


Hide 28800 4.INSTALL BATTERY

a.

Install the battery.


b.

Install the stay and bolt.


c.

Connect cable to positive battery terminal.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).