Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255793 HIGH INTENSITY DISCHARGE HEADLIGHT BULB A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 28800 3.REMOVE BATTERY

a.

Disconnect cable from positive battery terminal.


b.

Remove the bolt and stay.


c.

Remove the battery.


Hide 81108 4.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

a.
E247039

Disconnect the connector.


b.

Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly LH.

NOTICE:
·

Do not apply excessive force using a tool.

·

Do not damage the headlight gasket or allow it to become contaminated with foreign matter. If the headlight gasket is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly LH.




c.
E247040

Turn the headlight light control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly LH socket to remove the headlight light control ECU sub-assembly.

NOTICE:

Do not pull the headlight light control ECU sub-assembly LH with the socket connected.



Hide 81134 5.REMOVE HEADLIGHT GASKET

a.

Remove the headlight gasket from the headlight light control ECU sub-assembly LH.


Hide 81110L 6.REMOVE DISCHARGE HEADLIGHT BULB

a.
E247041

Release the set spring lock as shown in the illustration and remove the discharge headlight bulb.

NOTICE:

Do not touch the glass part of the discharge headlight bulb.