Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255797 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEADLIGHT LEVELING SWITCH

a.

Turn the ignition switch ON.


b.

Turn the headlight dimmer switch head.


c.
U166504E02
1.844,0.906 2.24,1.313 false 1.542,0.906 1.135,1.302 false 1.583,0.094 1.917,0.271 0.333,0.177 10 false G17 2.292,1.26 2.438,1.448 0.146,0.188 10 false T 1,1.24 1.146,1.427 0.146,0.188 10 false E

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G17-2 (T) - G17-5 (E) 0 10.44 to 11.16 V
(0.5) 9.48 to 10.2 V
1 8.52 to 9.24 V
(1.5) 7.56 to 8.28 V
2 6.6 to 7.32 V
(2.5) 5.64 to 6.36 V
3 4.68 to 5.4 V
(3.5) 3.72 to 4.44 V
4 2.76 to 3.48 V
(4.5) 1.8 to 2.52 V
5 0.84 to 1.56 V


If the result is not as specified, replace the headlight leveling switch.


d.

Check the illumination.

i.

Disconnect the connector.


ii.
U165780E01
1.567,0.174 1.896,0.352 0.330,0.178 10 G17 2.178,1.651 2.570,1.838 0.392,0.187 10 ILL+ 1.749,1.322 2.152,1.725 false 1.44,1.329 1.038,1.732 false 0.695,1.644 1.076,1.831 0.382,0.187 10 ILL-

Apply battery voltage to the connector and check the LED illumination conditions.

OK:
Measurement Condition Specified Condition
Battery positive (+) → G17-3 (ILL+)
Battery negative (-) → G17-4 (ILL-)
Illuminates


If the result is not as specified, replace the headlight leveling switch.