Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81564
1.REMOVE REAR COMBINATION LIGHT BODY GASKET LH
Remove the rear combination light body gasket LH.
The gasket must not be reused.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the bulb socket counter clockwise until the matchmark is aligned with the unlock position mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Position Mark |
Remove the rear turn signal light bulb from the bulb socket.
81565A
3.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
Detach the connector and wire harness clamp to remove the rear combination light socket and wire sub-assembly LH.