Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255805 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E157013E05
1.667,1.583 1.188,1.656 false 1.802,1.573 2.26,1.625 false 0.198,0.063 2.698,0.427 2.5,0.365 10 false Component without harness connected: (Hazard Warning Switch) 0.875,1.573 1.167,1.75 0.292,0.177 10 false ILL+ 2.271,1.542 2.531,1.719 0.26,0.177 10 false ILL-

Inspect the hazard warning switch LED illumination.

i.

Apply battery voltage to the connector, and check the LED illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Light illuminates



ii.
E157013E02
0.194,0.064 2.691,0.429 2.496,0.364 10 Component without harness connected: (Hazard Warning Switch) 1.051,1.507 1.342,1.688 0.291,0.181 10 F 1.517,1.542 1.203,1.595 false 2.293,1.471 2.549,1.652 0.256,0.181 10 E 1.937,1.516 2.274,1.574 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (F) - 1 (E) Hazard warning signal switch off 10 kΩ or higher
4 (F) - 1 (E) Hazard warning signal switch on Below 1 Ω


If the result is not as specified, there may be a malfunction in the hazard warning switch.