Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255806 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT STOP LIGHT SWITCH

a.

Disconnect the stop light switch connector.


b.
U165883E02
2.385,0.458 2.188,0.458 2.188,0.458 1.823,1.479 false 2.208,1.615 2.719,1.615 false 0.948,1.615 1.458,1.615 false 0.135,0.083 0.323,0.26 0.188,0.177 10 false *a 2.438,0.375 2.802,0.563 0.365,0.188 10 false GND 2.76,1.531 2.917,1.708 0.156,0.177 10 false B 0.813,1.531 0.969,1.708 0.156,0.177 10 false B 1.708,0.469 2.021,0.646 0.313,0.177 10 false A73

Measure the resistance and voltage on the wire harness side connector according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A73-3 (GND) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
A73-1 (B) - A73-3 (GND) Always 11 to 14 V
A73-5 (B) - A73-3 (GND) Engine switch on (IG)


If the result is not as specified, repair or replace the wire harness or connector.

Text in Illustration
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


c.

Reconnect the stop light switch connector.


d.
U166284E01
0.164,0.095 0.320,0.276 0.156,0.181 10 *a 1.166,1.593 1.315,1.801 0.149,0.208 12 L 1.521,1.08 1.25,1.57 false 1.819,1.883 2.253,2.039 0.434,0.156 10 GND 1.794,1.08 2.005,1.853 false 2.206,1.593 2.355,1.801 0.149,0.208 12 L 1.967,1.08 2.238,1.57 false 1.596,0.216 1.908,0.393 0.312,0.177 10 A73

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A73-2 (L) - A73-3 (GND) Brake pedal not depressed 0 to 1.5 V
Brake pedal depressed 7.5 to 14 V
A73-4 (L) - A73-3 (GND) Ignition switch on (IG)
Brake pedal not depressed
7.5 to 14 V
Ignition switch on (IG)
Brake pedal depressed
0 to 1.5 V


If the result is not as specified, replace the stop light switch assembly.

Text in Illustration
*a Component with harness connected
(Stop Light Switch Assembly)