Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255807 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.

Disconnect the automatic light control sensor connector.


b.
U163875E02
1.406,1.167 0.917,1.49 false 1.656,1.177 1.656,1.615 false 2,1.177 2.479,1.5 false 2.344,1.51 2.771,1.708 0.427,0.198 10 false CLTS 1.469,1.646 1.896,1.844 0.427,0.198 10 false CLTE 0.635,1.5 1.063,1.698 0.427,0.198 10 false CLTB 0.083,0.01 0.302,0.208 0.219,0.198 10 false *a 1.583,0.313 1.917,0.49 0.333,0.177 10 false F91

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
F91-2 (CLTE) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Switch Condition Specified Condition
F91-1 (CLTB) - F91-2 (CLTE) Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V


If the result not as specified, repair or replace the wire harness.

Text in Illustration
*a Front view of wire harness connector
(Automatic Light Control Sensor)


c.

Reconnect the automatic light control sensor connector.


d.
U166394E02
1.427,1.188 0.865,1.188 false 1.823,1.156 2.115,0.51 2.115,0.51 2.438,0.51 false 0.063,0.021 0.281,0.219 0.219,0.198 10 false *a 0.479,1.104 0.896,1.281 0.417,0.177 10 false CLTS 2.469,0.438 2.885,0.615 0.417,0.177 10 false CLTE 1.583,0.292 1.917,0.469 0.333,0.177 10 false F91

Connect an oscilloscope to the automatic light control sensor connector.


e.
E276298E01
2.844,1.646 3.219,1.813 0.375,0.167 10 false GND

Check the waveform.

Waveform:
Tester Connection Tool Setting Condition Specified Condition
F91-4 (CLTS) - F91-2 (CLTE) 2 V/DIV., 10 msec./ DIV. Engine switch on (IG), Light control switch in AUTO Correct waveform is as shown


HINT:

The communication waveform changes according to the surrounding brightness.


If the result is not as specified, replace the automatic light control sensor.

Text in Illustration
*a Component with harness connected
(Automatic Light Control Sensor)