1.INSPECT TURN SIGNAL FLASHER ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E19-7 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E19-1 (IG) - E19-7 (E) | Engine switch on (IG) | 11 to 14 V |
| E19-2 (LR) - E19-7 (E) | Hazard warning switch off | Below 1 V |
| Hazard warning switch on | 11 to 14 V | |
| E19-3 (LL) - E19-7 (E) | Hazard warning switch off | Below 1 V |
| Hazard warning switch on | 11 to 14 V | |
| E19-4 (B) - E19-7 (E) | Always | 11 to 14 V |
| E19-5 (EL) - E19-7 (E) | Headlight dimmer switch (TURN L) off | 9 V or higher |
| Headlight dimmer switch (TURN L) on | Below 1 V | |
| E19-6 (ER) - E19-7 (E) | Headlight dimmer switch (TURN R) off | 9 V or higher |
| Headlight dimmer switch (TURN R) on | Below 1 V | |
| E19-8 (HAZ) - E19-7 (E) | Hazard warning switch off | 9 V or higher |
| Hazard warning switch on | Below 1 V |
If the result is not as specified, there may be a malfunction in the turn signal flasher.