1.INSPECT TURN SIGNAL FLASHER ASSEMBLY
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (IG) - 7 (E) | Engine switch on (IG) | 11 to 14 V |
| 2 (LR) - 7 (E) | Hazard warning switch off | Below 1 V |
| Hazard warning switch on | 11 to 14 V | |
| 3 (LL) - 7 (E) | Hazard warning switch off | Below 1 V |
| Hazard warning switch on | 11 to 14 V | |
| 4 (B) - 7 (E) | Always | 11 to 14 V |
| 5 (EL) - 7 (E) | Headlight dimmer switch (Turn L) off | 9 V or higher |
| Headlight dimmer switch (Turn L) on | Below 1 V | |
| 6 (ER) - 7 (E) | Headlight dimmer switch (Turn R) off | 9 V or higher |
| Headlight dimmer switch (Turn R) on | Below 1 V | |
| 8 (HAZ) - 7 (E) | Hazard warning switch off | 9 V or higher |
| Hazard warning switch on | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (E) - Body ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the turn signal flasher.