The main body ECU receives a front fog light switch information signal from the light control switch (front fog switch), and illuminates the front fog lights.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
Using the intelligent tester, perform the Active Test (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Fog Light Relay | Front fog light | ON or OFF | - |
Fog light turns on/turns off.
OK
NG
Remove the fog light relay from the engine room relay block, junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
OK
NG
Remove the fog light relay from the engine room relay block, junction block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Fog light relay terminal 2 - Body ground | Light control switch tail | 11 to 14 V |
| Fog light relay terminal 5 - Body ground | Always |
| *a | Front view of wire harness connector
(to Fog Light Relay [FR FOG]) |
OK
NG
Remove the fog light relay from the engine room relay block, junction block.
Disconnect the E1 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Fog light relay terminal 1 - E1-4 (FFGO) | Always | Below 1 Ω |
| Fog light relay terminal 1 - Body ground | Always | 10 kΩ or higher |
OK
NG