The turn signal flasher receives a turn signal switch signal from the headlight dimmer switch, and illuminates the front turn signal light, side turn signal light and rear turn signal light.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
Check that the turn signal lights blink.
| Result | Proceed to |
|---|---|
| All turn signal lights do not blink | A |
| LH side turn signal light does not blink | B |
| RH side turn signal light does not blink | C |
A
B
C
Disconnect the turn signal flasher connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E19-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| E19-4 (B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E19-7 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Turn Signal Flasher Assembly) |
OK
NG
Disconnect the E19 turn signal flasher connector.
for Double Swing Out Type:
Disconnect the n1 rear combination light LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| n1-1 (TRN) - E19-3 (LL) | Always | Below 1 Ω |
| n1-4 (E) - Body ground | ||
| n1-1 (TRN) - Body ground | Always | 10 kΩ or higher |
except Double Swing Out Type:
Disconnect the K4 rear combination light LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K4-4 (TRN) - E19-3 (LL) | Always | Below 1 Ω |
| K4-3 (E) - Body ground | ||
| K4-4 (TRN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the E19 turn signal flasher connector.
for Double Swing Out Type:
Disconnect the Y1 rear combination light RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y1-3 (TRN) - E19-2 (LR) | Always | Below 1 Ω |
| Y1-6 (E) - Body ground | ||
| Y1-3 (TRN) - Body ground | Always | 10 kΩ or higher |
except Double Swing Out Type:
Disconnect the L3 rear combination light RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L3-4 (TRN) - E19-2 (LR) | Always | Below 1 Ω |
| L3-3 (E) - Body ground | ||
| L3-4 (TRN) - Body ground | Always | 10 kΩ or higher |
OK
NG