The turn signal flasher receives a turn signal light information signal from the headlight dimmer switch.
Remove the headlight dimmer switch (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT DIMMER SWITCH>INSPECTION).
for LH Side:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 13 (TR) - 12 (EL) | Turn signal switch right turn | Below 1 Ω |
| Turn signal switch off | 10 kΩ or higher | |
| 15 (TL) - 12 (EL) | Turn signal switch left turn | Below 1 Ω |
| Turn signal switch off | 10 kΩ or higher |
for RH Side:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 16 (TR) - 19 (EL) | Turn signal switch right turn | Below 1 Ω |
| Turn signal switch off | 10 kΩ or higher | |
| 18 (TL) - 19 (EL) | Turn signal switch left turn | Below 1 Ω |
| Turn signal switch off | 10 kΩ or higher |
OK
NG
Disconnect the E14 switch connector.
Disconnect the E19 relay connector.
for LH Side:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E14-13 (TR) - E19-6 (ER) | Always | Below 1 Ω |
| E14-15 (TL) - E19-5 (EL) | ||
| E14-12 (EL) - Body ground | ||
| E14-13 (TR) - Body ground | Always | 10 kΩ or higher |
| E14-15 (TL) - Body ground |
for RH Side:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E14-16 (TR) - E19-6 (ER) | Always | Below 1 Ω |
| E14-18 (TL) - E19-5 (EL) | ||
| E14-19 (EL) - Body ground | ||
| E14-16 (TR) - Body ground | Always | 10 kΩ or higher |
| E14-18 (TL) - Body ground |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C