The headlight leveling ECU*1 or headlight swivel ECU*2 stores this DTC if the sensor value received from the rear height control sensor LH is out of range when performing initialization of the headlight leveling ECU*1 or headlight swivel ECU*2; for example, the vehicle is not level or is being jacked up.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2452 | The sensor value received from the rear height control sensor LH is out of range when performing initialization. | ·
Vehicle condition when initializing ·
Headlight leveling ECU assembly (w/ Static Headlight Auto Leveling) ·
Headlight swivel ECU assembly (w/ Dynamic Headlight Auto Leveling) |
After replacing the headlight leveling ECU*1 or headlight swivel ECU*2, initialization of the ECU is necessary (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION).
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
Perform initialization of the headlight leveling ECU*1 or headlight swivel ECU*2 (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION).
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
Before initializing, make sure that the vehicle condition is proper for initialization.
Be sure to perform the initialization as instructed.
NEXT
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR).
DTC B2452 output does not occur.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Static Headlight Auto Leveling) | B |
| NG (w/ Dynamic Headlight Auto Leveling) (for LHD) | C |
| NG (w/ Dynamic Headlight Auto Leveling) (for RHD) | D |
If the headlight leveling ECU*1 or headlight swivel ECU*2 stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU*1 or headlight swivel ECU*2.
*1: w/ Static Headlight Auto Leveling
*2: w/ Dynamic Headlight Auto Leveling
A
B
C
D