Check that the stop lights illuminate when the brake pedal is depressed.
The stop lights illuminate when the brake pedal is depressed.
OK
NG
Disconnect the A24 hydraulic brake booster (skid control ECU) connector.
Disconnect the A39 stop light control relay connector.
Disconnect the S4 or T1 center stop light assembly connector.
Disconnect the L3 or Y1 rear combination light assembly RH connector.
Disconnect the K4 or n1 rear combination light assembly LH connector.
Disconnect the K49 or L87 radio setting condenser connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-45 (STP2) - A39-8 (OUT) | Always | Below 1 Ω |
| A24-45 (STP2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the S4 or T1 center stop light assembly connector.
Disconnect the L3 or Y1 rear combination light assembly RH connector.
Disconnect the K4 or n1 rear combination light assembly LH connector.
Disconnect the K49 or L87 radio setting condenser connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-8 (OUT) - Body ground | Brake pedal depressed | 11 to 14 V |
OK
NG