Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY(for Double Swing Out Type)
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255815 REAR COMBINATION LIGHT ASSEMBLY(for Double Swing Out Type) A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY(for Double Swing Out Type)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

a.
E233680E01
0.668,1.333 0.823,1.515 0.156,0.181 10 *1 0.839,1.428 1.25,1.718 false 2.902,0.706 3.058,0.887 0.156,0.181 10 *1 2.876,0.801 2.593,0.731 false

Put protective tape around the rear combination light assembly LH.

Text in Illustration
*1 Protective tape


b.

Remove the 2 bolts.


c.

Detach the 3 clips, 2 guides and 2 claws.

NOTICE:

Detach the bolt installation bracket from inside the body while being careful not to bend it.



d.

Disconnect the connector to remove the rear combination light assembly.


Hide 81550L 2.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E233681

Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.


Hide 81580B 3.REMOVE TAIL AND STOP LIGHT BULB

a.
E233682

Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.


b.

Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly LH.


Hide 81565A 4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH

a.
E233683

Using a screwdriver, detach the claw.


b.

Detach the 2 guide and remove the rear combination light socket and wire sub-assembly LH.