Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255820 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408D 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

E248559E01
1.904,0.034 2.415,0.189 0.511,0.155 10 *b 1.588,2.098 2.119,2.254 0.531,0.155 10 *d 2.31,1.135 2.802,1.310 0.491,0.175 10 *c 1.95,0.788 2.263,0.983 0.313,0.195 10 45° 1.703,1.544 2.016,1.739 0.313,0.195 10 45° 3.531,0.693 4.936,0.862 1.406,0.170 10 2 (SHRL) 3.39,2.362 3.934,2.537 0.544,0.175 10 3 (SHG) 5.552,1.368 6.070,1.534 0.518,0.166 10 1 (SHB) 5.172,1.948 5.026,2.443 false 3.979,2.443 5.035,2.443 false 4.01,0 6.513,0.323 2.503,0.323 10 *a 5.533,1.435 5.409,1.435 false 5.409,1.435 5.286,1.744 false 4.145,0.789 5.06,0.789 false 5.063,0.789 5.142,1.742 false 2.149,1.515 2.463,1.710 0.313,0.195 10 58° 2.207,0.598 2.521,0.793 0.313,0.195 10 56°

Text in Illustration
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b Low (-)
*c Normal *d High (+)

NOTICE:

Do not drop the height control sensor. If it is dropped, replace it with a new one.


a.

Connect 3 dry batteries of 1.5 V in series.


b.

Connect the positive (+) end of the batteries to terminal 1 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 3 (SHG).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRL) - 3 (SHG) High (+) Approx. 4.5 V
Normal Approx. 2.25 V
Low (-) Approx. 0.5 V


NOTICE:
·

Do not apply a voltage of higher than 6 V.

·

Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.