Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (w/ Towing Hitch) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255831 REAR BUMPER(w/ Towing Hitch) A

EXTERIOR PANELS / TRIM  REAR BUMPER(w/ Towing Hitch)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 58724B 1.INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

a.

Install the No. 2 luggage compartment side cover protector with 2 new grommets.


b.

Install the 2 screws.


Hide 58723B 2.INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

HINT:

Use the same procedure described for the LH side.


Hide 57616B 3.INSTALL REAR BUMPER ARM BRACKET LH

a.

Install the rear bumper arm bracket LH with the 2 bolts.


b.

Connect the connector.


Hide 57615C 4.INSTALL REAR BUMPER ARM BRACKET

a.

Install the rear bumper arm bracket with the bolt.

HINT:

Use the same procedure to install the rear bumper arm bracket on the other side.



Hide 52172B 5.INSTALL REAR NO. 2 BUMPER REINFORCEMENT

a.

Install the rear No. 2 bumper reinforcement with the 2 bolts.


Hide 52156A 6.INSTALL REAR BUMPER SIDE SUPPORT LH

a.

Attach the 6 claws to install the rear bumper side support LH.


b.

Install the 3 screws.


Hide 52155A 7.INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 52563D 8.INSTALL REAR UPPER BUMPER RETAINER LH

a.

Attach the 2 clips to install the rear upper bumper retainer LH.


Hide 52562E 9.INSTALL REAR UPPER BUMPER RETAINER RH

HINT:

Use the same procedure described for the LH side.


Hide 81560 10.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

Hide 81550 11.INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52159 12.INSTALL REAR BUMPER COVER

a.

w/ TOYOTA Parking Assist-sensor System:

Connect the No. 2 frame wire connector.


b.

Attach the 14 claws to install the rear bumper cover.


c.

Install the 7 bolts, 6 screws and 2 clips.


d.

Open the tail gate and install the 4 clips.


e.

Close the tail gate.


Hide 52162B 13.INSTALL REAR NO. 1 BUMPER PLATE

a.

Attach the 20 claws to install the rear No. 1 bumper plate.


Hide 76626E 14.INSTALL REAR QUARTER PANEL MUDGUARD LH

Hide 76625G 15.INSTALL REAR QUARTER PANEL MUDGUARD RH