Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE STEP
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255849 SIDE STEP A

EXTERIOR PANELS / TRIM  SIDE STEP  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 51793B 1.REMOVE NO. 1 SIDE STEP BRACKET LH

B180954

a.

Remove the 2 bolts and side step bracket.


Hide 51796 2.REMOVE NO. 2 SIDE STEP BRACKET LH

B180953

a.

Remove the 2 bolts and side step bracket.


Hide 51797A 3.REMOVE NO. 3 SIDE STEP BRACKET LH

B180952

a.

Remove the 2 bolts and side step bracket.


Hide 51792C 4.REMOVE REAR STEP PANEL LH

a.

Put a 4 mm (0.157 in.) drill bit into a drill.


b.
U155856E01
0.413,0.925 0.812,1.206 0.399,0.281 10 5 mm

Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill, as shown in the illustration.

HINT:

Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.



c.

Lightly press the drill against the 2 rivets, drill off the flanges of the 2 rivets, and remove the rear step panel.

NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.

·

Be careful of the drilled rivet as it may become hot.




d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.


Hide 51774A 5.REMOVE FRONT SIDE DOOR STEP PLATE COVER LH

B180956

a.

Remove the 2 screws and side step bracket.


Hide 51759A 6.REMOVE REAR SIDE DOOR STEP PLATE COVER LH

B180955

a.

Remove the 2 screws and side step bracket.


Hide 51775C 7.REMOVE NO. 1 SIDE DOOR STEP PLATE MOULDING

a.

Remove the step plate moulding.

B180951