51776B
1.INSTALL REAR NO. 2 STEP COVER (w/ Towing Hitch)
Attach the 4 claws to install the rear No. 2 step cover.
Install the 2 screws and 2 clips.
52169C
2.INSTALL REAR LOWER BUMPER COVER (w/ Towing Hitch)
Install the rear lower bumper cover with the clip.
51776B
3.INSTALL REAR NO. 2 STEP COVER (w/ Pintle Hook)
Attach the 10 claws to install the rear No. 2 step cover.
52463
4.INSTALL REAR BUMPER PAD LH
When installing the rear bumper pad, heat the rear bumper cover using a heat light.
| Item | Temperature |
|---|---|
| Rear Bumper Cover | 20 to 30°C (68 to 86°F) |
Do not heat the rear bumper cover excessively.
When using a new rear bumper cover:
Clean the surface of a new rear bumper cover.
Using a heat light, heat the rear bumper cover surface.
When reusing the rear bumper cover:
Using a heat light, heat the rear bumper cover surface.
Remove the double-sided tape from the rear bumper cover.
Wipe off any tape adhesive residue with cleaner.
Install a new rear bumper pad.
Remove the peeling paper from the face of a new rear bumper pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Align the rear bumper pad with the mark-off line of the rear bumper.
Install the rear bumper pad.
52462
5.INSTALL REAR BUMPER PAD RH
Use the same procedure described for the LH side.
81680
6.INSTALL BACK-UP LIGHT ASSEMBLY LH
81670
7.INSTALL BACK-UP LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52187C
8.INSTALL REAR BUMPER NO. 2 SIDE BRACKET (w/ Tire Carrier)
Attach the 3 claws to install the rear bumper No. 2 side bracket.
52189B
9.INSTALL REAR BUMPER NO. 3 SIDE BRACKET (w/ Tire Carrier)
Install the rear bumper No. 3 side bracket with the 2 screws.
52166A
10.INSTALL REAR BUMPER UPPER COVER LH
Attach the 4 claws to install the rear bumper upper cover.
52165A
11.INSTALL REAR BUMPER UPPER COVER RH
Use the same procedure described for the LH side.
52615
12.INSTALL REAR BUMPER ENERGY ABSORBER
Attach the 8 claws to install the rear bumper energy absorber.
82165
13.INSTALL NO. 2 FRAME WIRE
Attach the 13 clamps to install the No. 2 frame wire.
Connect the 2 connectors.