Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75798B
1.INSTALL REAR DOOR REAR NO. 1 OUTSIDE MOULDING PAD
When installing the rear door rear No. 1 outside moulding pad, heat the rear door outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Outside Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the rear door outside moulding excessively.
When using a new rear door outside moulding:
Clean the surface of a new rear door outside moulding.
Using a heat light, heat the rear door outside moulding surface.
When reusing the rear door outside moulding:
Using a heat light, heat the rear door outside moulding surface.
Remove the double-sided tape from the front door outside moulding.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door rear No. 1 outside moulding pad.
Remove the peeling paper from the face of a new rear door rear No. 1 outside moulding pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Align the rear door rear No. 1 outside moulding pad with the mark-off line of the rear door outside moulding and install it as shown in the illustration.
Press the rear door rear No. 1 outside moulding pad firmly to install it.
| *a | Mark-off Line |
75076
2.REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH
When installing the rear door outside moulding sub-assembly LH, heat the vehicle body and rear door outside moulding sub-assembly LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Door Outside Moulding Sub-assembly LH | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body and rear door outside moulding sub-assembly LH excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install the rear door outside moulding sub-assembly LH.
Using a heat light, heat the vehicle body and rear door outside moulding sub-assembly LH.
Remove the peeling paper from the face of the rear door outside moulding sub-assembly LH.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the 4 clips to install the rear door outside moulding sub-assembly LH.
Press the rear door outside moulding sub-assembly LH firmly to install it.