Home › Vehicle Exterior › WINCH › REMOTE CONTROL SWITCH
RM2660E _59 Vehicle Exterior _052858 WINCH _0255864 REMOTE CONTROL SWITCH G

WINCH  REMOTE CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT OVERHEAT TEMPERATURE INDICATOR

B167945E01
1.371,1.557 1.558,1.694 0.187,0.137 10 (-) 2.229,1.557 2.431,1.705 0.201,0.147 10 (+) 1.401,1.232 1.512,1.371 0.111,0.139 10 E 2.005,0.905 2.115,1.043 0.111,0.139 10 B 1.599,0.572 2.007,0.98 false 1.26,0.765 1.455,1.248 false

a.

Apply battery voltage and check operation of the remote control switch, as shown in the table below.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal B
Battery negative (-) → Terminal E
Overheat temperature indicator light illuminates and buzzer sounds


If the result is not as specified, replace the remote control switch assembly.


Hide 38640 2.INSPECT REMOTE CONTROL SWITCH CIRCUIT

B168131E01
2.817,0.294 2.944,0.440 0.127,0.147 10 A 2.817,0.839 2.948,0.985 0.130,0.147 10 B 2.817,1.179 2.946,1.325 0.128,0.147 10 C 0.497,1.727 0.639,1.887 0.142,0.161 10 D 0.497,1.179 0.614,1.321 0.117,0.142 10 E 0.497,0.839 0.616,0.990 0.119,0.151 10 F 2.08,0.923 2.795,0.923 false 2.082,1.26 2.797,1.26 false 0.652,0.925 1.366,0.925 false 0.654,1.261 1.369,1.261 false 1.785,0.744 2.567,0.377 2.567,0.377 2.771,0.377 false 1.659,1.45 0.877,1.817 0.877,1.817 0.673,1.817 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
A - B*1
B - C
B - E*2
Not pushed Below 1 Ω
B - D Pushed to IN Below 1 Ω
B - F Pushed to OUT Below 1 Ω


HINT:
·

*1: Connect the positive (+) lead of the ohmmeter to terminal B and the negative (-) lead to terminal A.

·

*2: Connect the positive (+) lead of the ohmmeter to terminal E and the negative (-) lead to terminal B.



If the result is not as specified, replace the remote control switch assembly.