Home › Vehicle Exterior › WINCH › RELAY › from 2015.08
RM2660E _59 Vehicle Exterior _052858 WINCH _0255865 RELAY A

WINCH  RELAY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE WINCH MAIN RELAY

a.

Disconnect the connector.


b.

Remove the 2 nuts and disconnect the 2 wires.


c.

Remove the 3 nuts and relay.

B180493