Use these procedures to troubleshoot the power window control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| B2311 is output | B |
| B2312 is output | B |
| B2313 is output | B |
| LIN communication system DTCs are output | C |
A
B
C
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Door window regulator and power window regulator motor assembly is replaced or removed/installed. | A |
| Door window regulator and power window regulator motor assembly is not replaced or removed/installed. | B |
A
B
If a power window switch LED is blinking, initialize the power window regulator motor.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT