Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052841 METER / GAUGE / DISPLAY _0255598 METER / GAUGE SYSTEM Y

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the meter/gauge system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR



c.

Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system DTC or meter/gauge system DTC by simulating the symptoms indicated by the DTC.


Result:
Result Proceed to
DTC is not output A
CAN communication system (for LHD) DTC is output B
CAN communication system (for RHD) DTC is output C
Meter/gauge system DTC is output D



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

4.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACE
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END