Use the following procedure to troubleshoot the G-BOOK system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
The G-BOOK system provides a variety of functions. Therefore, it is important to identify whether a malfunction is related to the communication system, including radio wave conditions, or any other systems. Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal condition caused the malfunction.
| Displayed Message and Problem Symptom | Cause |
|---|---|
| A message is displayed temporarily indicating to try again after moving the vehicle because the center cannot be accessed, as the screen cannot be displayed due to a busy line, etc. | This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is). |
| A message is displayed temporarily indicating to try again after waiting for a while because the information cannot be retrieved due to a busy line, etc. | This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is). |
| A message is displayed temporarily indicating to try again after waiting for a while because the lines are busy. | This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunctions and ask them to use the system as is). |
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output. | A |
| CAN communication system DTC is output. | B |
A
B
Refer to Problem Symptoms Table.
Click hereAudio / Visual / Telematics>G-BOOK>G-BOOK SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. CAN communication system DTC is output. | B |
If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
A
B
Refer to Terminals of ECU.
Click hereAudio / Visual / Telematics>G-BOOK>G-BOOK SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
Adjust, repair or replace as necessary.
If the multi-media module receiver assembly is replaced, perform the vehicle contract setting.
Click hereAudio / Visual / Telematics>G-BOOK>G-BOOK SYSTEM>REGISTRATION
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT