Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/o Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255479 AUDIO AND VISUAL SYSTEM(w/o Navigation System) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/o Navigation System)  HOW TO PROCEED WITH TROUBLESHOOTING  


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the engine switch on (IG).


b.

Check whether or not the radio receiver assembly turns on.


Result:
Result Proceed to
Radio receiver assembly turns on A
Radio receiver assembly does not turn on B



A

4.CHECK FOR DTC

B

6.PROBLEM SYMPTOMS TABLE
4.CHECK FOR DTC
HINT:

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>DTC CHECK / CLEAR


a.

Check for DTCs and note any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs by simulating the operation indicated by the DTCs.

HINT:
·

If the system cannot enter diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the malfunctioning part.

·

Even if the symptom malfunction is not confirmed, check the DTCs. This is because the system stores history DTCs.

·

Check and clear history DTCs. Then recheck for DTCs.




Result:
Result Proceed to
DTC is output again A
DTC is not output B



A

5.DIAGNOSTIC TROUBLE CODE CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DIAGNOSTIC TROUBLE CODE CHART
HINT:

Refer to Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>DIAGNOSTIC TROUBLE CODE CHART


Result:
Proceed to
NEXT



NEXT

8.ADJUST, REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE
HINT:

Refer to Problem Symptoms Table .

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>PROBLEM SYMPTOMS TABLE


Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING

B

8.ADJUST, REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END