Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/o Stereo Component Amplifier) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255477 AUDIO AND VISUAL SYSTEM(w/o Stereo Component Amplifier) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/o Stereo Component Amplifier)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the audio and visual system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the ignition switch to ACC.


b.

Check whether or not the display appears on the radio receiver.


Result:
Result Proceed to
Display appears A
Display does not appear B



A

4.CHECK FOR DTC

B

5.PROBLEM SYMPTOMS TABLE
4.CHECK FOR DTC
a.

Check for DTCs and note any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs. Based on the DTC output in the first step, try to force output of the audio system DTC by simulating the operation indicated by the DTC.

HINT:
·

If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.

·

Even if the malfunction symptom is not confirmed, check for DTCs as the system stores past DTCs.

·

Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.




Result:
Result Proceed to
DTC is not output A
DTC is output B



A

5.PROBLEM SYMPTOMS TABLE

B

7.ADJUST , REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING

B

7.ADJUST , REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

7.ADJUST , REPAIR OR REPLACE
7.ADJUST , REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

END