*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Measure the voltage of the battery.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check and record DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Symptom does not occur. | A |
| Symptom occurs. | B |
A
B
Perform symptom simulation.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for 1VD-FTV with DPF)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output. | A |
| CAN communication system DTC is output. | B |
If any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.
Refer to the following procedures.
Refer to the following procedures.
If communication with the power steering ECU cannot be established through the GTS, inspect terminals CANH and CANL of the DLC3 and power steering ECU, and the IG circuit of the power steering ECU.
A
B
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for 1VD-FTV with DPF)>DTC CHECK / CLEAR
Refer to Diagnostic Trouble Code Chart when any DTCs are output.
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
A
B
Refer to Problem Symptoms Table.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for 1VD-FTV with DPF)>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT